Visual Inspection: Conduct a final, thorough visual check. Verify no wires are pinched and all connectors are fully seated and their locking mechanisms engaged.
* Reconnect Batteries: Reconnect the negative battery cables.
* Power-Up: Turn the key switch to the ON position (do not start the engine). Observe the monitor for any immediate warning or error messages.
* Diagnostic Tool: Connect the Cat ET diagnostic tool. Check the Implement ECM for active or logged diagnostic codes. Clear any historical codes.
* Switch & Sensor Test: Use Cat ET's "monitor status" or "switch status" function to test every single switch, button, and thumbwheel on the console. Verify that Cat ET recognizes each input correctly when you activate it.
* Joystick Calibration: THIS IS A CRITICAL AND MANDATORY STEP. After a harness replacement, the Implement ECM must recalibrate the joysticks and travel pedals. This procedure is done exclusively through Cat ET. It guides the operator to move each control through its full range of motion so the ECM can learn the minimum, maximum, and neutral signal values. Incorrect calibration will result in poor machine response, unintended movements, or activation of diagnostic codes.
This 572-2418 console harness is used for 374F 390F C15 C18 excavator.
Related part number:
196-8876
342-2974
9X-3401
126-1767
281-3132
281-3133
455-0707
8T-8737
247-2695
9X-3402
126-1768
3S-2093
7Y-3967
7Y-3963
7Y-3965
125-7874
125-7875
